0
Owner's of the Casio Electronic Keyboard Digital Piano gave it a score of 0 out of 5. Here's how the scores stacked up:
E-47
English
Reference
Troubleshooting
Problem Cause Action
See
Page
No sound is produced when I
press a keyboard key.
1. The VOLUME controller is set to
“MIN”.
1. Rotate the VOLUME controller more towards
“MAX”.
) E-6
2. Headphones or an adaptor plug is
plugged into one of the PHONES
jacks.
2. Disconnect whatever is connected to the
PHONES jacks.
) E-45
3. MIDI Local control is turned off. 3. Turn on the Local control setting. ) E-24
The pitch of the Digital Piano
is off.
1. The Digital Piano’s key setting is
something other than “440.0Hz”.
1. Change the key setting to “440.0Hz”, or turn
Digital Piano power off and then back on
again.
) E-24
2. Digital Piano tuning is incorrect. 2. Adjust Digital Piano tuning, or turn the Digital
Piano off and then back on again.
) E-24
3. Octave shift is enabled. 3. Change the octave shift setting to 0. ) E-24
4. A non-standard temperament
setting is being used.
4. Change the temperament setting to
“00: Equal”, which is the standard modern
tuning.
) E-24
Nothing happens when I
press a pedal.
The pedal unit cable is not connected. Connect the cable correctly. ) E-43
Tones and/or effects sound
strange. Turning power off
and then back on again does
not eliminate the problem.
Example:
Note intensity does
not change even though I
alter key pressure.
The “Back up” feature is turned on. Turn off “Back up”. Next, turn power off and then
back on again.
) E-25
I cannot transfer data after
connecting the Digital Piano
to a computer.
– 1. Check to make sure that the USB cable is
connected to the Digital Piano and computer,
and that the correct device is selected with
your computer’s music software.
) E-35
2. Turn off the Digital Piano and then exit the
music software on your computer. Next, turn
the Digital Piano back on and then restart the
music software on your computer.
I cannot store data to a USB
flash drive or load data from a
USB flash drive.
– See “Error Indicators”. ) E-33
It takes a long time before I
can use the Digital Piano after
I turn it on.
Digital Piano memory data was
corrupted because a data transfer
operation with a computer was in
progress the last time you turned off
the Digital Piano. When this happens,
the Digital Piano performs a memory
format operation the next time you turn
it on. You cannot perform any other
operation while a format operation is in
progress.
It takes about 20 seconds after you turn on
power to perform the memory format operation.
Wait until the format operation is complete. Note
that you should take care to avoid turning off the
Digital Piano while a data transfer operation with
a computer is in progress.
) E-36
A tone’s quality and volume
sounds slightly different
depending where it is played
on the keyboard.
This is an unavoidable result of the digital sampling process,
*
and does not indicate malfunction.
* Multiple digital samples are taken for the low range, middle range, and high range of the original
musical instrument. Because of this, there may be very slight differences in tonal quality and
volume between sample ranges.
When I press a button, the
note that is sounding cuts out
momentarily or there is a
slight change in how effects
are applied.
This happens when the sounds of multiple parts are sounding at the same time while using layer,
using the Duet Mode, playing back a built-in tune, recording, etc. Pressing a button when one of
these conditions exists will cause the effect setting that is built into the tone to change automatically,
which causes notes to cut out momentarily or causes a slight change in how effects are being
applied.
Find Your Products By Category
Please Login
