Samson Music Mixer MIXPAD STEREO MIXERS User Manual

0

Out of 0 Ratings

Owner's of the Samson Music Mixer MIXPAD STEREO MIXERS gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 24
 
9
The MXP124FX has a built-in stereo USB audio interface allowing you to record
and playback from a computer using virtually any digital recording software.
Setting up your mixer with a computer is a simple procedure that takes just
a few minutes. The following section describes how to connect and setup the
MXP124FX with a computer.
1. Connect the MXP124FX to the
computer using a standard USB
cable (not included).
2. In your audio software, set the
input and output device to the
MXP124FX.
3. The audio sent from the
MXP124FX to the computer
follows the Main Mix bus.
4. For playback, you can return the
USB stereo signal directly into the
main left and right mix bus so that
the playback from the PC sums
with the MAIN mix on the console. To hear the USB playback in the MAIN
MIX press the TAPE/USB TO MAIN MIX switch.
5. The TAPE/USB TO MIX 2 + PHONES switch is used to assign the USB
return to the Mix 2 and headphones bus. This allows you to mix the
playback in studio monitors or isolate the playback to a mix zone.
USB Connectivity (MXP124FX Only)

   Find Your Products By Category